| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE KEY TO TURN THE MACHINE OFF.
|
| 2 |
|
LOCATE THE FOOT PEDAL. NOTE: ENGAGE THE SEAT SWITCH OR VOLT METER WILL ALWAYS READ ZERO.
|
| 3 |
|
PUSH THE PIN IN TO OPEN THE FOOT PEDAL.NOTE: BE CAREFUL, THE PEDAL IS SPRING LOADED AND WILL POP UP.
| Screwdriver-flat tip |
|
|
| 4 |
|
TURN THE SET SCREW TO ADJUST THE POTENTIOMETER.
| Wrench-Allen standard 1/16 in |
|
|
| 5 |
|
REMOVE THE 10 SCREWS FROM THE CONTROL PANEL TO EXPOSE THE CONTROL BOARD. REMOVE THE CONTROL BOARD COVER.
| Wrench-Allen standard 1/8 in |
|
|
| 6 |
|
REMOVE THE WIRE LABELED TRACTION FROM THE CONTROL BOARD. TURN THE MACHINE ON.
|
| 7 |
|
INSERT THE VOLT METER PROBES INTO THE CONTROL BOARD WHERE THE TRACTION PLUG WAS. ADJUST THE SET SCREW UNTIL THE VOLT METER READS ZERO. WHEN IT READS ZERO, YOU HAVE FOUND NEUTRAL.
| Volt meter (True RMS capable) |
&Width=100)
|
|
| 8 |
|
REVERSE STEPS 3 THRU 6 TO REASSEMBLE THE MACHINE.
|